Quality of Service Guide QoS Shapers and Shaper QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 437
10.2.2.2 Applying a Shaper Group
Shaper groups are applied to SAPs on Epipe, Ipipe, and VPLS services, and to
interface SAPs on IES and VPRN services. The shaper group must exist within the
shaper policy assigned to an MDA.
When an unshaped-sap-shaper-group is configured within a shaper policy, it is
automatically applied to the unshaped SAPs on the MDA. Operators do not need to
specifically apply the unshaped SAP shaper group.
Use the following CLI syntax to apply a shaper group to a VPLS SAP. The syntax is
similar for Epipe and Ipipe SAPs. The syntax is also similar for IES and VPRN
services, except that the SAP is configured on a service interface.
CLI Syntax: config>service>vpls>sap#
egress
[no] shaper-group name
ingress
[no] shaper-group name
The following output shows shaper group “sg1” applied to access ingress traffic on a
VPLS SAP:
*A:ALU>config>service>vpls>sap>ingress# info detail
----------------------------------------------
qos 1
no match-qinq-dot1p
scheduler-mode 16-priority
no agg-rate-limit
shaper-group sg1
----------------------------------------------
*A:ALU>config>service>vpls>sap>ingress#
To Next Page
Loading...
