System Management Guide Security
Edition: 01 3HE 11018 AAAC TQZZA 135
3.10.2.1.9 RADIUS Client Commands
radius
Syntax [no] radius
Context config>system>security
Description This command enables the context to configure RADIUS authentication on the 7705 SAR.
For redundancy, multiple server addresses can be configured for each 7705 SAR.
The no form of the command removes the RADIUS configuration.
access-algorithm
Syntax access-algorithm {direct | round-robin}
[no] access-algorithm
Context config>system>security>radius
Description This command configures the algorithm used to access the set of RADIUS servers. Up to five
servers can be configured.
In direct mode, the first server, as defined by the server command, is the primary server. This
server is always used first when authenticating a request. In round-robin mode, the server
used to authenticate a request is the next server in the list, following the last authentication
request. For example, if server 1 is used to authenticate the first request, server 2 is used to
authenticate the second request, and so on.
Default direct
Parameters direct — first server is always used to authenticate a request
round-robin — server used to authenticate a request is the next server in the list,
following the last authentication request
accounting
Syntax [no] accounting
Context config>system>security>radius
Description This command enables RADIUS accounting. The no form of this command disables RADIUS
accounting.
Default no accounting
To Next Page
Loading...
