System Management Guide Security
Edition: 01 3HE 11018 AAAC TQZZA 145
auth-port — the UDP port number used to contact the RADIUS server for authentication
Values 1 to 65535
acct-port — the UDP port number used to contact the RADIUS server for accounting
requests
Values 1 to 65535
server-type — the server type
Values authorization, accounting, or combined
source-address
Syntax source-address ip-address
no source-address
Context config>system>security>dot1x>radius-plcy
Description This command configures the NAS IP address to be sent in the RADIUS packet.
The no form of the command reverts to the default value.
Default system IP address
Parameters ip-address — the source address of the RADIUS packet in dotted-decimal notation
Values 0.0.0.0 to 255.255.255.255
shutdown
Syntax [no] shutdown
Context config>system>security>dot1x
config>system>security>dot1x>radius-plcy
Description This command administratively disables the 802.1x protocol operation. Shutting down the
protocol does not remove or change the configuration other than the administrative state.
The operational state of the entity is disabled as well as the operational state of any entities
contained within.
The no form of the command administratively enables the protocol.
Default shutdown
To Next Page
Loading...
