Event and Accounting Logs
296
System Management Guide
3HE 11018 AAAC TQZZA Edition: 01
5.12.2.1.2 Accounting Policy Commands
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy acct-policy-id
Context config>log
Description This command creates an access or network accounting policy. An accounting policy defines
the accounting records that are created.
Access accounting policies are policies that can be applied to one or more service access
points (SAPs). Changes made to an existing policy, using any of the sub-commands, are
applied immediately to all SAPs where this policy is applied.
Network accounting policies are policies that can be applied to one or more network ports.
Changes made to an existing policy, using any of the sub-commands, are applied
immediately to all network ports where this policy is applied.
If an accounting policy is not specified on a SAP or network port, accounting records are
produced in accordance with the access or network policy designated as the default. For
more information, see the default command.
The no form of the command deletes the policy from the configuration. The accounting policy
cannot be deleted unless it is removed from all the SAPs or network ports where the policy is
applied. Use the show>log>accounting-policy command to see where an accounting
policy is used and which accounting policy is the default policy.
Default n/a
Parameters acct-policy-id — the policy ID that uniquely identifies the accounting policy, expressed as
a decimal integer
Values 1 to 99
collection-interval
Syntax collection-interval minutes
no collection-interval
Context config>log>accounting-policy
Description This command configures the interval between collection of accounting records.
Parameters minutes — the interval, in minutes, at which accounting records are collected
Values 1 to 120
To Next Page
Loading...
