System Management Guide Event and Accounting Logs
Edition: 01 3HE 11018 AAAC TQZZA 307
5.12.2.1.5 Log Filter Commands
filter
Syntax [no] filter filter-id
Context config>log
Description This command creates a context for an event filter. An event filter specifies whether to
forward or drop an event or trap based on the match criteria.
Filters are configured in the filter filter-id context and then applied to a log in the log-id log-
id context. Only events for the configured log source streams destined for the log ID where
the filter is applied are filtered.
Any changes made to an existing filter, using any of the sub-commands, are immediately
applied to the destinations where the filter is applied.
The no form of the command removes the filter association from log IDs, which causes those
logs to forward all events.
Default No event filters are defined.
Parameters filter-id — uniquely identifies the filter
Values 1 to 1001
Default 1001
default-action
Syntax default-action {drop | forward}
no default-action
Context config>log>filter
Description The default action specifies the action that is applied to events when no action is specified in
the event filter entries or when an event does not match the specified criteria.
When multiple default-action commands are entered, the last command overwrites the
previous command.
The no form of the command reverts to the default value.
Default default-action forward
Parameters drop — the events that are not explicitly forwarded by an event filter match are dropped
forward — the events that are not explicitly dropped by an event filter match are
forwarded
To Next Page
Loading...
