Nokia 8850 - Page 70

AT Command Set for Nokia 8850 69
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
+CDS New SMS-STATUS-REPORT
text mode:
+CDS: <fo>,<mr>,[<ra>],[<tora>], <scts>,<dt>,<st>
PDU mode:
+CDS: <length><CR><LF><pdu>
- when +CNMI=0:
routed messages are buffered into TA/ME (if buffer is full, 'memory capacity
exceeded' should be sent to network)
- when +CNMI=1:
in on-line data state routed messages are rejected (e.g. 'memory capacity exceeded'
is sent to network and when command mode is entered 'memory available' is sent to
network); in command mode forwarded directly to TE
- when +CNMI=2:
in on-line data state routed messages are buffered into TA/ME (if buffer is full,
'memory capacity exceeded' should be sent to network and when command mode is
entered 'memory available' should be sent to network); in command mode forwarded
directly to TE
- when +CNMI=3 and V.80 in-band mode enabled:
routed messages forwarded directly to TE
- when +CNMI=3 and V.80 in-band mode is disabled or not supported:
behaves like +CNMI=2 case
See also command +CNMI, page 27. (GSM 07.05 section 3.4.1).
+CDSI New SMS-STATUS-REPORT Indication
+CDSI: <mem>,<index>
- when +CNMI=0:
indications are buffered into TA/ME
- when +CNMI=1:
in on-line data state indications are discarded; in command mode forwarded directly
to TE
- when +CNMI=2:
in on-line data state indications are buffered into TA/ME; in command mode
forwarded directly to TE
- when +CNMI=3 and V.80 in-band mode enabled:
forwarded directly to TE
- when +CNMI=3 and V.80 in-band mode is disabled or not supported:
behaves like in the case of +CNMI=2
See also command +CNMI, page 27. (GSM 07.05 section 3.4.1).
+CMS ERROR Message Service Failure
+CMS ERROR: <err>
given instead of ERROR when error is related to ME or network operation
See also the Error Values section, page 56. (GSM 07.05 section 3.2.5).