Nokia 9210 - Page 7

CONFIDENTIAL
7 (17)
RAE-3 Repairhints
Customer Care Europe & Africa Version 2.0 Approved
SCCE Training Group 13.03.2002
© 2002 Nokia Mobile Phones
Checked by:
Customer Care Training Group
Approved by:
SCCE
Flash menu with modified RAE3.ini file
Choose Erase Only to reset
the flash D353
- After erasing the emulated eeprom, part of the XIP flash D353, the display shows contact service.
- Now flash the phone without marking erase only.
- After flash update set Full Factory and Accessory
(for Accessory see also chapter 4 “Connection with
any kind of accessory not possible”) under menu
software/ Set Factory values (See picture below),
also rewrite product code and HW-ID.
- Rewrite IMEI and SIMlock data if the procedure is permitted to you and tune the phone
- If the erase only procedure not works change the D353 flash.
- After changing the D353 Flash EEPROM, flash the phone. If the SW update was successful, make a full factory and Accessory
set, then rewrite the product code and the HW-ID. After that, rewrite IMEI and SIMlock data.
- If the sw update is not successful, probably D300 MADLINDA is faulty. Up to HW 4.00, the D300 is not changeable because of
underfill.
From HW-ID 4.23 with OSP, the MADLINDA is changeable. (See SB-027)
(Note! Everytime when it is necessary to change the D353 EEPROM or erase the EEPROM, a Full Factory set and
Asseccory set
must be done!
Note! Rewrite SIMlock and IMEI data by use of NOKIA SECURITY PASSWORD and make a SW-update again, if the
procedure is permitted to you. (See SB–037)