Mounting the Switch Chassis and Power Supplies
page 3-22 OmniSwitch 6360 Hardware Users Guide April 2021
Airflow Recommendations
To ensure proper airflow, be sure that your switch is placed in a clean, well-ventilated area free of dust and
debris and provide minimum recommended clearance at the front, back and sides of the switch, as shown
below. Restricted airflow can cause your switch to overheat, which can lead to switch failure. Refer to the
following important guidelines regarding airflow:
Follow the guidelines below regarding the minimum clearance requirements when mounting
the chassis.
Chassis Top View
Note. Clearance is not required at the top and bottom of the chassis.
}
}
Rear. 6 inches minimum
at rear of chassis.
Front. 6 inches minimum
at front of chassis.
Sides. 2 inches minimum
at left and right sides.
To Next Page
Loading...