Chassis and Power Supplies Installing Available Rack Mounting Kits
OmniSwitch 6360 Hardware Users Guide April 2021 page 3-29
Installing Available Rack Mounting Kits
Note. Some factory-installed screws may need to be removed prior to mounting, depending on the kit
being used.
Installing the OS6360-RM-L Rack Mount Kit
A single chassis can also be mounted into a standard 19-inch rack using L-brackets, as shown in the figure
below.
1 Attach rack mount brackets to both sides of the front of the chassis.The long and short bracket can be
mounted on either side of the chassis.
Attach Rack Mount Brackets
2 Align the holes in the flanges with the rack holes and insert rack mount screws (not provided) through
the bottom hole of each flange and then the top of each flange. Tighten both screws until they are secure
Rack-mounting Single Chassis
Follow the recommended clearance requirements for the
model type being mounted.
To Next Page
Loading...