Nokia I nt ernal Use Only | Co pyrig ht © 20 1 2 Nokia | A ll right s reserved
1) Start assembling the DISPLAY/UI SHIELD by
connecting the DISPLAY connector.
2) Turn over the DISPLAY/UI SHIELD as shown and
slightly press to fold the DISPLAY connector flex.
3) Turn the DISPLAY /UI SHIELD back to its p lace.
Slightly press the DISPLAY connector flex again so
that it is folded twice.
4) Be sure to position the SPEAKER GASKET to its
place before assembling the IHF SPEAKER. Leaving
the SPEAKER GASKET out can result in damage to
other magnetic devices
5) Tighten the four TORX+ size 6 screws to the
torque of 14 Ncm in the order shown.
6) Tighten the two TORX+ size 4 screws to the
torque of 12 Ncm in the order shown.
To Next Page
Loading...
