Nokia ASHA 303 RM-763 - Page 13

Nokia Asha 303
RM-763
Service Manual Level 1&2
13
Co nf id e nt ial | Cop yright © 2011 Nokia | A ll rights reserved
V e rs io n 1 .0
5) Remove the END CAP.
6) Use the SS-93 to release the two shown clips
holding the QWERTY KEYMAT. Make sure that the
QWERTY KEYMAT is levered out completely.
7) Remove the QWERTY KEYMAT.
8) Unscrew the two Torx+ size 4 screws in the order
shown.
9) Unscrew the four Torx+ size 6 screws in the order
shown. Do not use them again. Discard them.
10) Separate the ENGINE BOARD including the A-
COVER from the B-COVER by pushing up from the
bottom s ide of the ENGI NE BOARD.