ENGLISH
Get started
The headset contains the following
parts shown on the title page:
multifunction key (1), earloop (2),
indicator light (3), earpiece (4),
microphone (5), and charger
connector (6).
Before using the headset, you must
charge the battery and pair the
headset with a compatible device.
Compatible chargers
This device is intended for use when
supplied with power from the
following chargers: AC-3, AC-4, AC-5,
AC-8, DC-4 and DC-9. The exact
charger model number may vary
depending on the type of plug. The
plug variant is identified by one of the
following: E, X, AR, U, A, C, K, or B.
Charge the battery
1. Connect the charger to a wall
outlet.
2. Connect the charger cable to the
charger connector.
To charge the headset when it is in
the clip or car cradle, insert the
lower end of the headset into the
clip or car cradle (12), and connect
the charger cable to the charger
connector on the clip or cradle
(13).
The red indicator light is displayed
during charging. Charging the
battery fully may take up to 2
hours.
3. When the battery is fully charged,
the green indicator light is
displayed. Disconnect the charger
from the headset (or from the clip
9222327_enu1.fm Page 4 Wednesday, July 14, 2010 12:03 PM
To Next Page
Loading...
