Nokia C110

47
After inserting the wireless LAN card, it takes a while before the computer responds.
It is true that there might be a pause while the driver initializes the wireless LAN
card. This is normal. Please wait until the next message box appears and tells you
what to do. This should not take more than a few minutes.
Installation to a network drive fails.
You cannot install the Nokia C110/C111 Wireless LAN Card software onto a
network drive. The software must always be installed on a local hard drive.
After inserting the wireless LAN card, Windows 95 starts installing a network client on
my computer.
If there is no network client installed on your computer, Windows automatically
starts installing it when you insert the wireless LAN card. When the network client
installation is finished, Windows asks you to restart the computer (YES/NO). You
must select NO and continue with the wireless LAN card installation. Restart the
computer after the card installation is complete.
Windows NT 4.0 starts installing NT Networking on my computer.
You must have NT Networking installed on your computer. If you do not have
NT Networking installed, a dialog box opens asking if you want to install it now.
Click Yes and follow the instructions given in the wizard. Note that you need the
Windows NT installation files during this procedure. The order in which the
various installation files are used is: first the Nokia C110/C111 installation files,
then the Windows NT installation files, and finally the Nokia C110/C111 files
again.
The computer was shut down or it stopped responding during installation, and the
software cannot be installed or uninstalled.
Go to Start, click Run, and type regedit. Click OK. The following registry entries
should be deleted in the Registry Editor window:
• HKEY_LOCAL_MACHINE\Software\Microsoft\Windows\CurrentVersion\Un
install\{BFA1B53A-C809-11D3-AABD-0008C79B73DF}
• HKEY_LOCAL_MACHINE\Software\Nokia\C11x WLAN Card\Installation
After deleting these, install the software again. It is recommended that you let your
system administrator remove the registry entries.
When installing or uninstalling the software, an error message appears: “Error
installing:ikernel.exe.”
You must have local administrator rights when installing or uninstalling in
Windows NT 4.0 or Windows 2000.