ONT configuration file over OMCI
3FE-49441-ABAA-TCZZA
Issue 1
9.4.1 Configuring an ONT using a configuration file via legacy method
1
Upload the ABCXXXXVER TAR file to the /ONT/ directory in the OLT.
A maximum of 250 files can be kept in the OLT file system.
2
Using OLT commands, download the TAR file to the ONT.
For OLT commands, refer to the , or the 7342 ISAM FTTU Operation and Maintenance Using
TL1 and CLI.
Please note:
• pri-cfgfile-pland/dnload or
sec-cfgfile-pland/dnload
can be 1 to 14 characters.
• pri-cfgfile-pland and pri-cfgfile-dnload should be the same name.
Examples
Note: X can be 1 or 2 unless specified:
a. If pland-cfgfileX= Disabled and dnload-cfgfileX= Disabled ,
no file will be downloaded to the ONT.
b. If
pland-cfgfileX=FILENAME1
and dnload-cfgfileX= Disabled ,
FILENAME1 will be downloaded and FILENAME1 will be made active. An ONT reboot is
required.
c. If
pland-cfgfileX=Disabled
and dnload-cfgfileX= FILENAME2
FILENAME2 will be downloaded and FILENAME2 will be made passive. An ONT reboot is
not required.
d. If
pland-cfgfileX=FILENAME3
and dnload-cfgfileX= FILENAME 4, the OLT reports an
error because the filenames are not the same.
e. Configure equipment interface
pland-cfgfile1=XMLXXXXXX1
and dnload-cfgfile1
XMLXXXXXX1
Configure equipment interface
pland-cfgfile2=XMLXXXXXX2
and dnload-cfgfile2
XMLXXXXXX2
Although the OLT permits the above two steps without reporting an error, Nokia does not
recommend executing them, because the ONT may exhibit unexpected behavior.
f. If pland-cfgfileX=Auto and
dnload-cfgfileX=
Auto
The OLT will download the XML file from "sw-ctr-list" (configure equipment ont sw-ctrl)
E
ND OF
STEPS
The ONT will distribute the configuration files to the different services based on the active indication
from the OLT and on the Nokia defined index.
The ONT automatically reboots to apply the configuration files. After the ONT reboots and reports
the active version, the OLT completes the file download procedure.
To Next Page
Loading...
