5. TV installation
Set your TV
Put your TV on a rm place which can handle the weight of the TV. To avoid danger, please do not position the
TV near water or heat sources (such as light, candle, heater), do not block the ventilation at the back of the TV.
Connect antenna and power
1. Connect the antenna cable to the antenna socket on the back of the TV.
2. Plug in the power cord of your TV (AC 100-240 V~ 50/60 Hz). The TV enters standby mode (red light).
3. Turn on your TV by pressing the power button of the TV or the power button on the remote control.
4. In case you have purchased a TV model with 12 Volt adapter included - use the right port to connect
the adapter to the TV set.
10
10 cm10 cm
10 cm
ON
ANTENNA
13/18 V 400 mA max
SATELLITE
2
1
3
4
To Next Page
Loading...