nokmmk75410bsAaltoPrismQSGC_en_id.fh11 Mon Oct 29 10:39:19 2007 Page 10
Composite
C M Y CM MY CY CMY K
nokmmk75410bs Aalto Prism Quick Start Guide Cover Close size: 166mm(W) x 120mm(H) / Open Size: 332mm(W) x 120mm(H)
Part code: 9206564
Basic Phone Set-up
8
Eject the memory card
Important: Do not remove the memory card in the middle of an
operation when the card is being accessed. Removing the card
in the middle of an operation may damage the memory card as
well as the device, and data stored on the card may be corrupted.
1 Before you eject the card, press and select Remove
memory card. All applications will be closed.
2 When Removing memory card will close all open
applications. Remove anyway?
is displayed, select Yes.
3 When Remove memory card and press OK is displayed,
open the door of the memory card slot.
4 Press the memory card to release it from the slot.
5 Pull out the memory card and select OK.
Memory card tool
Press and select Tools > Memory.
To back up information from the device memory to a
compatible memory card (if available), select
Options > Back
up phone memory.
The device notifies you if the memory
card does not have enough free space to create a back-up.
To restore information from the compatible memory card
to the device memory, select
Options > Restore from card.
When a memory card is reformatted, all data on the card is
permanently lost. Some memory cards are supplied
preformatted and others require formatting. Consult your
retailer to find out if you must format the memory card
before you can use it.
To format a memory card, select
Options > Format memory
card
. Select Yes to confirm.
Basic Phone Set-up
9
Switch the device on
1 Press and hold .
2 If the device asks for a (U)PIN code or lock code, enter it,
and press . The factory setting for the lock code is 12345.
Your device has internal antennas.
Note: As with any radio transmitting device, avoid touching an
antenna unnecessarily when the antenna is in use. For example,
avoid touching the cellular antenna during a phone call. Contact
with a transmitting or receiving antenna affects the quality of
the radio communication, may cause the device to operate at a
higher power level than otherwise needed, and may reduce the
battery life.
Charge the battery
1 Connect a compatible charger
to a wall outlet.
2 Connect the power cord to the
device. If the battery is completely
discharged, it may take a while
before the charging indicator
starts scrolling.
3 When the battery is fully charged, the charging indicator
stops scrolling. Disconnect the charger from the device,
then from the wall outlet.
Keypad lock (keyguard)
When the keys are locked, is displayed.
To lock the keys, press , then .
To unlock the keys, open the 2-way slide,
or press , then .
When the keys are locked, opening the camera lens cover
unlocks the keys.
To have the keypad lock activated automatically after a time-
out or when the 2-way slide is closed, press , and select
Tools > Settings > General > Security > Phone & SIM card.
When the keypad lock is on, calls may be possible to the
official emergency number programmed into your device.
Cellular antenna
Bluetooth technology/
wireless LAN antenna