WEP key in use — Select the wired equivalent privacy (WEP) key
number. You can create up to four WEP keys. The same settings must be
entered on the WLAN access point device.
Authentication type — Select Open or Shared for the authentication
type between your device and the WLAN access point device.
WEP key settings — Enter WEP encryption (length of the key), WEP
key format (ASCII or Hexadecimal), and WEP key (the WEP key data in
the selected format).
Security settings for 802.1x and WPA/WPA2
Define the 802.1x or WPA/WPA2 security settings if you have selected either
as the WLAN security mode.
1 Select Menu > Settings and Connectivity > Destinations.
2 Open the access point group that has the desired WLAN access point, and
select the access point.
You can also define 802.1x or WPA/WPA2 settings when creating a new
WLAN access point.
3 Select WLAN security mode > WPA/WPA2 or 802.1x.
4 Select WLAN security settings > WPA/WPA2 > EAP to use an
extensible authentication protocol (EAP) plug-in, or Pre-shared key to
use a password. The same password must be entered on the WLAN access
point device.
If you selected EAP, define the EAP plug-in settings according to the
instructions from your service provider.
Connections in WPA2 only mode are applicable to WPA2 enabled devices
only.
The available options may vary.
154 Connectivity
© 2010 Nokia. All rights reserved.
To Next Page
Loading...
