Do not use the Product outside, and make sure all the connections
are indoors.
Do not install, use, or service this Product during a thunderstorm.
There is a remote risk of electric shock from lightning.
Caution - Potential equipment damage
Follow these recommendations to protect yourself and the
Product from harm:
• Do not look directly at the optical port without protection.
• Do not insert any sharp object into the openings of a
Product.
• Do not put the Product near a heat source. Avoid placing the
Product in direct sunlight.
• Do not put the Product in damp or wet locations; for example,
near a bathtub, washbowl, kitchen sink or laundry tub, in a wet
basement, or near a swimming pool. Do not spill any liquid on
the Product.
• Do not touch the Product or its power adapter or cord with
wet hands.
• Do not place the Product on an unstable surface or support.
• Do not place heavy objects on top of the Products.
• Do not use liquid or aerosol cleaners; unplug the Product and
use a soft, dry cloth for cleaning.
• When connecting a PC or other electronic device to a Product,
make sure you use the right cables and connect the device to
the right port of the Product. Incorrect connections may
damage the device and/or the Product.
• Do not open or try to open the Product. Opening or removing
covers can expose you to dangerous high voltage points or
other risks.
It is recommended that users and other individuals maintain a
distance of at least 10 cm between themselves and the Product to
avoid exposure. The Product contains components that emit an
electromagnetic field and could interfere with pacemakers or
other electronic medical devices. If you have a pacemaker or other
implantable or personal medical device, please consult your
physician or medical device manufacture about the required
minimum safe distance between the Product and your medical
device.
Keep your product and accessories out of reach of pets. They
could damage it and cause injury or electrocuting.
If the Product malfunctions or fails to perform as expected, stop
using it immediately.
The product is expected to operate at a temperature of -5 to 45
degrees Celsius for a relative humidity between 10% and 90%.
3. Install the ONT
1. Connect the power cable to the case on the PWR power port.
2. Connect the power socket to the wall socket
3. Remove the protective cap on the OPTICAL port of the case.
4. Remove the protective cap from the fiber optic.
5. Connect the optical fiber to the optical port of the case.
6. Connect the case to the home router via the Ethernet cable.
7. Push the ON/OFF button to be “ON”.
4. EU Declaration of Conformity
Hereby, Nokia Solutions and Networks Oy declares that
the Product is in compliance with Radio Equipment Directive
2014/53/EU; Low Voltage Directive 2014/35/EU; EMC Directive
2014/30/EU, Directive RoHS 2011/65/EU and 2015/863/EU, and
Directive Eco-design 2009/125/EC. The full text of the EU
declaration of conformity, as well as additional compliance
information, is available at www.nokia.com/notices/declaration-
of-conformity/.
Products are for indoor use only.
In accordance with Article 10.8(a) and 10.8(b) of the RED, the
following tables provide information on the frequency bands used
and the maximum radio frequency transmit power of the Products
for sale in the EU and other countries of sale:
Specific precautions for EMC Warning
The Products are compliant with Class B of EN 55032. In
a residential environment, this equipment may cause radio
interference. The Products are tested to the requirements of EN
55032 (Emissions) and EN 55024 (immunity). There are no specific
precautions which must be taken in order to comply with the
requirements of Directive 2014/30/EU Essential Requirements in
Section 1 of Annex I. In addition, the Products are further tested to
ensure spurious emissions are within the specified limits, as well as
meeting the requirements for adaptivity, which mitigates against
problems caused by co-location with other wireless products. The
Products are not subject to the requirements in Section 2 of Annex
I of Directive 2014/30/EU for fixed installations.
End of Life Collection and Treatment
In the European Union and European Economic Area,
this label indicates that this product should not be
disposed of with household waste. It should be
deposited in an appropriate facility to enable
recovery and recycling.
The Product is marked with this symbol, which is
known as the WEEE mark. WEEE stands for Waste Electronics and
To Next Page
Loading...
