18
Save Setup – Choose YES or NO to save the setup for later use. If you choose to
save settings, enter a name to identify the saved settings.
Additional Settings:
Alarm 1: Able to set as follows: Off, Seismic, Air, both. If you choose Seismic, Air,
or Both, set the trigger level for the sensor(s) selected.
Alarm 1 Time: Range: 0.5-60.0 seconds in 0.5 second increments. This is the
amount of time the alarm output will pull to GND reference.
Alarm 2: Able to set as follows: Off, Seismic, Air, both. If you choose Seismic, Air,
or Both, set the trigger level for the sensor(s) selected.
Alarm 2 Time: Range: 0.5-60.0 seconds in 0.5 second increments. This is the
amount of time the alarm output will pull to GND reference.
To Next Page
Loading...