Use this option to view the type sensor provided with the unit and the
maximum vibration level for that sensor. The sensors available are X1 (20
IPS/508 mm max), X2 (10 IPS/254 mm max), X4 (5 IPS/127 mm max), and
X8 (2.5 IPS/63 mm max).
Use this option to view the serial number of the instrument. This serial
number can only be set at the NOMIS facility.
Use this option to choose times the unit will be operating and monitoring for
vibrations. When the timer has the instrument turned off, the unit will operate
on very little power and will not trigger.
1. Make sure the current date and time is correct BEFORE using timer
mode. If you change the date and time after timer mode is set, timer
mode will automatically be cancelled.
2. Choose ENABLE to use timer mode.
3. Choose one of the following options:
1. ONE TIME – One time on and off of the unit. After this one time,
it will not occur again.
To Next Page
Loading...