press to pop out the SIM card holder, and then take it out. Correctly
place the storage card into card slot 2, and then inset the holder into
the mobile phone.
Please turn off the mobile phone before taking out the storage card,
insert the pin into the lateral pinhole and press to pop up the card
holder and take it out.
Tips: 1. This phone does not support memory card hot plug.
2. The slot 2 is compatible to both SIM card and storage card,
but both kinds of card cannot be placed simultaneously.
1.3 Remove and install the battery
The battery is built-in.
Note: the battery of the phone cannot be removed manually.
1.3.1 Battery Charging
When the new battery is not fully charged, before the use of mobile
phone, you should use up the power of the battery, and then charge
the battery by the following ways.
1. Insert the connector of the charger into the charger socket of the
mobile phone.
2. Insert the charger into the power supply, the battery symbol will
be dynamically displayed, indicating that the battery is being
charged.
When charging is finished, the full battery symbol will be displayed,
to prompt that charging is finished.
After charging is finished, please remove the charger from the
power supply, and then unplug the charging plug from the mobile
phone.
Tips: you can charge your mobile phone through USB data
connecting line and the computer connection. If the battery power
of your mobile phone has been fully used up, it may be impossible
to charge the mobile phone through USB data connecting line. At
this time, you should use the charger to charge the mobile phone.
2.
Basic Operation
2.1 Power On/Off the Phone
Long press the power key to turn on/off the mobile phone.
To Next Page
Loading...
