TopKlip
After adjusting TopKlip to diameter and width of the carrier, the
accessory can be attached to the bike. When setting down the ac-
cessory on the carrier, always ensure that the red rubber inserts
rest on the carrier rails
6
. Also make sure that the rear bracket is
always positioned in front of one of the carrier’s cross braces
7
.
The accessory is secured by turning the levers downwards. The
levers can be moved along the spring rod. Ensure that no tubes
or the bike’s battery prevent the levers from locking into place
completely
8
.
Universal quick release for carriers with Ø 10-16mm and 9-16cm
width. Set down the accessory – turn levers – done !
Important: Make sure that the accessory is securely mounted
before each ride. Remove the accessory before transporting
the bike on a car rack.
GB
To Next Page
Loading...
