EasyManua.ls Logo

Nord Drivesystems SK 200E Series - Page 67

Nord Drivesystems SK 200E Series
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6 Parameters
BU 0210 en-3117 67
P546 Function Bus setpoint S P
Arrays
[-01] … [-03]
Scope of Application
Description
In this parameter, during bus actuation a function is allocated to the setpoint provided.
Setting values
Value Meaning
Pos: 27 2 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par amet er/ Par amet erau fli st ung (P 000 .. .)/P OS ICON/ S afet y/P 500 bis P59 9 (P OSI CON/ sa fet y)/P 546 - F kt . Bus -Soll w ert_ Eins tell wer te_ 01 @ 1 4\mod_1479723911445_388.docx @ 2305749 @ @ 1
0
Off
The bus setpoint is not used.
20
BusIO Out Bits 0-7
BusIO Out Bits 0-7 of the frequency inverter
21 Set position Low word
Lower 16-bit value of the set position (absolute position) of the
frequency inverter
22
Setpoint pos. High word
Upper 16-bit value of the set position (absolute position) of the
frequency inverter
23
Setpoint pos. Inc.Low word
Lower 16-bit value of the set position (relative position) of the
frequency inverter
24 Setpoint pos. inc. High word
Upper 16-bit value of the set position (relative position) of the
frequency inverter
25
Gear ratio factor
Setting of the speed ratio between the master and the slave
Pos: 27 6 /Anlei tung en/El ektr onik/FU und Star ter/5 . Par amet er/ Par amet erau fli st ung (P 000 .. .)/P OS ICON/ S afet y/P 500 bis P59 9 (P OSI CON/ sa fet y)/P 552 - CAN Mas ter Zy klus @ 14\mod_1479725831915_388.docx @ 2305924 @ @ 1
P552 CAN master cycle S
Setting range
0 … 100
Arrays
[-01] =
CAN master function, cycle time system bus master function
[-02] = CANopen abs. encoder, cycle time CANopen absolute encoder
Factory setting
{ 0 }
Description
Setting of the cycle time in the cycle time system bus master mode or to CANopen
absolute encoders
Note
With setting "0" a default value is used, which depends on the selected baud rate
(P514). For details see Section 4.2.2.1 "Supplementary settings CANopen
absolute encoders"
Pos: 27 7 /Allg emein/ Allg emeing ültig e Mod ule/---------Sei tenumbr uch ko mpakt --------- @ 13\mod_1476369695906_0.docx @ 2265495 @ @ 1

Table of Contents

Related product manuals