Nord Drivesystems SK 530P - Page 164

NORDAC PRO (SK 500P) – Users Manual for Frequency Inverters
164 BU 0600 en-2319
P704 Volt. last error S
Display range 0 ... 600 V AC
Arrays
[-01] … [-10]
Description
„
Last voltage error 1 … 10
“. This parameter stores the output voltage that was being
delivered at the time the fault occurred. The values of the last 10 errors are stored.
P705 Dc.lnk volt. last er. S
Display range 0 ... 1000 V DC
Arrays
[-01] … [-10]
Description
"Link circuit voltage last error 1 … 10“. This parameter stores the link circuit voltage
that was being delivered at the time the error occurred. The values of the last 10
errors are stored.
P706 P set last error S
Display range 0 ... 3
Arrays
[-01] … [-10]
Description
„
Parameter set last error 1 … 10
“. This parameter stores the parameter set code that
was active when the error occurred. Data for the previous 10 faults are stored.
P707 Software version
Display range 0.0 ... 9999.9
Arrays
[-01] =
Version number (Vx.x)
[-02] =
Revision number (Rx)
[-03] = Special version of hardware/software (0.0)
Description
„Software version / Revision“. This parameter shows the software and revision
numbers in the FI. This can be significant when different FIs are assigned the same
settings.
Array [-03] provides information about any special versions of the hardware or
software A zero stands for the standard version.