Nord Drivesystems SK 530P - Display; Displays; Operation

3 Options
BU 0600 en-2319 57
3.2.2 Display
3.2.2.1 Displays
1
Inverter load display (with 100% value)
2
Parameter set display
3
Five digit 7-segment display with prefix and 4 x point
4
Three digit 14-segment display for units
5 Enable right and enable left
6 4 Inverter status displays
3.2.2.2 Operation
5-digit,
7-segment
LED display
Operating mode
Display
Comments
Ready for
operation
without setpoint
present
If the underscores flash slowly the frequency
inverter is not ready for operation:
• Starting disabled: Function “Safe pulse block“
or "Fast stop active"
• Enable signal present before the frequency
inverter is ready for operation.
In operation Numerical display Display of actual frequency.
In case of fault
Displays the present
fault message. Display
lights up red.
Slow flashing of the display indicates that the fault
is no longer present and the error message can
be acknowledged.
Parameterisation
Parameter value
Parameter group:
Example motor data (P2 - -)
Parameter number:
Example nominal speed (P202)
Parameter value
Example: 1360 rpm