Nord Drivesystems SK 750E-751-323-A - Parameterisation; Additional Parameters

NORDAC SK 750E Manual
116 Technical design subject to change BU 0750 GB
Parameter
Setting value / Description / Note
Parameter
set
Available with option
P546
Func. bus-setpoint 1
P
immer sichtbar
0 ... 7
[ 1 ]
When the inverter is bus-controlled, this parameter allows for allocating a function to the transmitted
setpoint 1.
Note: For more details see the applicable bus operating instructions.
0 = Off
1 = Setpoint freq. 16bit
2 = Setpoint posn. 16bit
3 = Setpoint posn. 32bit
4 = PosiCon
5 = Setp. posn. 16bit inc
6 = Setp. posn. 32bit inc
7 = BusIO In Bits 0-7
P547
Func. bus-setpoint 2
P
Always available
0 ... 20
[ 0 ]
When the inverter is bus-controlled, this parameter allows for allocating a function to the transmitted
setpoint 2.
Note: For further details see the applicable bus operating instructions.
0 = Off
1 = Nominal frequency
2 = Torque current limit
3 = PID current freq.
4 = Frequency addition
5 = Frequency subtract.
6 = Current limit
7 = Maximum frequency
8 = PID ltd.current.freq.
9 = PID suprvsd.cur.freq
10 = Servo-Mode Torque
11 = Pre-tension Torque
12 = PosiCon
3
control bits (only withPosiCon option)
13 = Multiplication
14 = Cur.val process ctrl
15 = Nom.val process ctrl.
16 = Add. Process control
17 = Bus I/O In-bits 0-7
18 = Cam control mode calculator
19 = Set relais (P541)
20 = Set analogue output (P542)
P548
Func. bus-setpoint 3
P
Always available
0 ... 20
[ 0 ]
When the inverter is bus-controlled, this parameter allows for allocating a function to the transmitted
setpoint 3. Only available if P546 3.
Note: For further details see the applicable bus operating instructions.
This parameter is identical with P547.