Nord Drivesystems SK 750E-751-323-A - Mounting and Installation; On the Motor and Close to the Motor

NORDAC SK 750E manual
12 Technical design subject to change BU 0750 GB
2 Mounting and installation
2.1 On the motor and close to the motor
SK 750E frequency inverters designed for integration are fitted directly to the motor by means of an attachment
frame and "mounting feet" so as to represent a functional drive unit.
Design for integration:
Shown: SK 750E, IP54 design (air-cooled)
Optional Technology Unit
SK TU2-CTR
SK TU2-POT
Optional Technology Unit
Bus subassemblies
Optional custom interface
SK CU1-...
Optional special extension
SK XU1-...
If the SK 750E frequency inverter is designed for installation close to the motor, it can be mounted somewhere
near, as for instance on a wall or on a machine frame. In that case a wall mounting kit will be required (cf. Sec-
tion 2.5).
Installation close to motor:
Optional Technology Unit
SK TU2-CTR
SK TU2-POT
Optional Technology Unit
Bus subassemblies
Optional custom interface
SK CU1-...
Optional special extension
SK XU1-...
Shown: SK 750E, type IP54 (air cooling)