Nord Drivesystems SK 750E-751-323-A - Documentation; List of Versions;Updates; Use of the Frequency Inverters as Intended by the Manufacturer; Operating Instructions

NORDAC SK 750E Manual Regarding the present document
BU 0750 GB 3
Documentation
Designation/Name/Title: BU 0750 GB
Part no.: 607 75 02
Device series: SK 750E
List of versions/updates
Titles of previous editions
Last up-
date s.w.
Remarks
BU 0750 GB, December 2004
V 3.1 R1
First edition, based on BU 0700 GB
BU 0750 GB, December 2005
V 3.1 R2
Revision, completion and correction
BU 0750 GB, April 2006
V 3.2 R0
Revision, wall mounting kit, motor mounting, differen-
tiation of the options for IP54 and IP65 design, cable
clamp screws
BU 0750 GB, March 2007
Mat. no.: 6077501 / 1207
V 3.2 R0
Data storage via P550 only using the right slot, Sec-
tion 3.2 Right / left slot
BU 0750 GB, March 2008
Mat. no.: 6077502 / 1208
V3.4 R4
Electro magnetic motor brake control connection,
P217, P426, P533, P535
Editor
Getriebebau NORD GmbH & Co. KG
Rudolf- Diesel- Str. 1 D-22941 Bargteheide http://www.nord.com/
Phone +49 (0) 45 32 / 401-0 Fax +49 (0) 45 32 / 401-555
Use of the frequency inverters as intended by the manufacturer
For operation to proceed without trouble and for possible warranty claims to be satisfied, fol-
lowing the Operating Instructions is indispensable. So please read the Operating Instructions
first before starting to work with the device!
The Operating Instructions contain important information regarding the service. That is why
they should be kept near where the device is being used.
SK 750E frequency inverters are designed for industrial plant to operate three-phase asynchro-
nous motors with squirrel-cage rotors. These motors must be suitable to be controlled by fre-
quency inverters. The frequency inverters do not allow for any other loads to be connected.
SK 750E frequency inverters are devices designed for stationary installation. All of the informa-
tion provided with regard to the technical data and the conditions admissible at the site where
they are used must be strictly adhered to without exception.
The devices must not be put into operation (i.e. operation as intended by the manufacturer must
not be started) until it has been established that the machine in question actually meets the re-
quirements mentioned in the EMC directive 89/336/EEC and until conformity of the final product
with the directive 89/392/EEC for machines has been verified (EN 60204 to be observed).
Getriebebau NORD GmbH & Co. KG, 2008