Nord Drivesystems SK 750E-751-323-A - Parameterisation; Display of Array Parameters

7 Parameterisation
BU 0750 GB Technical design subject to change 79
Example: parameter availability / parameter description
Parameter Setting value / Description / Note
Parameter
set
Available with option
BSC STD MLT
P000
…-01
…-02
…
Operational status
P
BUS ENC POS
Typical layout
0.01 … 9999
[ 0 ]
Only with ControlBox option as selected in P001
The operating parameter selected in parameter P001 is shown here.
Text of parameter
Array values
Parameter number
Value range of parameter
Default setting of parameter
Selective parameter (P), different values can be defined in 4
parameter sets; selection in P100
Custom interface: BSC = Basic I / O
Custom interface: MLT = Multi I/O oder Multi I/O 20mA
Special extension: ENC = incremental encoder module
BUS = bus custom interfaces
Custom interface: STD = Standard I / O
Special extension: POS = positioning module
7.1 Display of array parameters
Some parameters provide for several levels (arrays) of settings and views
to be displayed. When the parameter has been selected, the system pre-
sents its array levels and waits for a selection to be made.
If the ParameterBox SK PAR-… is used (figure opposite), the array level
options will be shown in the top right-hand corner of the screen.
Important
When a type SK 750E inverter is combined with a ControlBox,
only the first array level of an array parameter will be displayed.
The ControlBox does not provide for displaying any of the other
array levels however.
Only provided that the inverter is associated with the Parame-
terBox will it be possible to have the program display all array
levels of the individual array parameters!
ParameterBox, SK PAR-2H