Nord Drivesystems SK PAR-2H - Page 28

NORDAC Control and Parameter Boxes
28 Subject to technical alterations BU 0040 GB-1611
Menu structure of the ParameterBox
The menu structure consists of various levels which are each arranged in a ring structure. The ENTER key moves
the menu on to the next level. Simultaneous operation of the SELECTION keys moves the menu back a level.
Parameter 1
management
P1201 2
Copy - Source
P1202 2
Copy - Start
P1204 2
Load default values
P1203 2
Copy - Start
P1205 2
Delete memory
P0 2
Back
Parameterisation 1
Display 1
P1001 2
Bus scan
P1002 2
FI selection
P1004 2
Values for display
P1003 2
Display mode
P1005 2
Standardisation factor
P0 2
Back
Options 1
P1301 2
Language
P1302 2
Operating mode
P1304 2
Contrast
P1303 2
Automatic bus scan
P1305 2
Set password
P1306 2
Box password
P0
zurück
700E 3,0kW/3 POS STD
1
Fi/Hz U/V I/O
45.0 360 3.4
ONLINE I1 P1 R RUNNING
U1 U2 U3 U4 U5
1 - - - -
OK - - - -
100
P1307 2
Reset box param.
P0 2
Back
P0
zurück
P1308 2
NORDAC p-box
Version 4.0 R3
Basic parameters 2
>ENTER< (to level 3.)
P0 2
Back
Inverter menu structure,
dependent on installed
options (e.g. posicion, etc.)
Æ Inverter manual
Motor data 2
>ENTER< (to level 3.)
Operating displays 2
>ENTER< (to level 3 .)
P1101 2
Object selection
Note:
Parameter P1101 only appears when one or several
datasets are stored in the box or when several units are
interconnected via RS485.
Basic parameters 2
>ENTER< (to level 3.)
Motor data 2
>ENTER< (to level 3.)
>Display< (P11xx), >Administer Parameters< (P12xx) and >Options< (P13xx) are purely ParameterBox-
parameters and do not have any direct influence on frequency inverter parameters.
Access to the frequency inverter menu structure is gained via the
>Parameterisation< menu. The details depend on
the equipment of the frequency inverter with customer interfaces (SK CU1-…) and/or special expansions (SK XU1-).
For the description of the parameterisation and the parameters, please refer to the particular inverter manual.