NORDAC Control and Parameter Boxes
30
Subject to technical alterations BU 0040 GB-1611
Parameterisation in ControlBox mode
Parametrisation
of the frequency inverter in ControlBox mode is carried out in the same way as for
parameterisation with the SimpleBox. A detailed description can be found in Section 2.2.1 under
"
Parameterisation with the SimpleBox“.
Menu structure in ControlBox mode
The menu structure in ControlBox mode corresponds to that of the SimpleBox. A detailed description can be found
in Section 2.2.1 under "
Menu structure with the SimpleBox“.
Visualisation mode PLC (firmware version V4.3 or higher, available from about the 3th quarter of 2011)
From firmware version V4.3 (Parameter (P1308)) the ParameterBox is equipped with the visualisation mode "PLC
display". This mode is activated in parameter (P1003).
n this mode, communication of the ParameterBox with the PLC (SPS) of a suitably equipped NORD frequency
inverter (e.g. SK 540E / SK 545E) is possible so that the PLC can use the entire display can be used as a display
interface.
Further information regarding the PLC is described in the manual BU0550.
To Next Page
Loading...