NORDAC Control and Parameter Boxes
24 Subject to technical alterations BU 0040 GB-1611
2.2.2 ParameterBox
2.2.2.1 Display
After the ParameterBox is connected and the mains voltage for the inverter is switched on, an automatic "Bus
scan" is performed. The ParameterBox identifies the connected frequency inverter(s). The frequency inverter type
and its current operating status can be seen in the following display.
300E 0,75kW/3 BSC … 1
> NORDAC <
Frequency inverter
ONLINE
I1 P1 Ready
In the standard display mode, 3 operating values and the current frequency inverter status can be displayed
simultaneously.
The operating values displayed can be selected from a list of 8 possible values (in Menu>Display</>Values for
display<).
300E 0,75kW/3 BSC … 1
Fi/Hz U/V I/A
45.0 190 1.4
ONLINE
I1 P1 R RUNNING
Current status
of the inverter
Inverter type
Current actual
values for the
selected operating
values and their
applicable units
Current
ParameterBox status
Inverter
selected
Active parameters
in inverter
Current status of
the inverter
Inverter type
Menu structure level
Customer's interface,
special expansion
To Next Page
Loading...