NORDAC Control and Parameter Boxes
40 Subject to technical alterations BU 0040 GB-1611
2.5 Accessories for NORDAC parameterisation boxes
2.5.1
SK IC1-232/485 interface converter
The
SK IC1-232/485 interface converter converts signals from RS485 to RS232.
This converter is used for connecting a PC or a laptop to a NORDAC frequency
inverter (RS485) or to a series PAR-2x ParameterBox.
With the aid of the NORD CON software the frequency inverter or the
ParameterBox can be controlled and parameterised. In addition, the software
provides a convenient diagnostic tool with an oscilloscope function in order to
enable the optimisation of drive solutions. (
SK IC1-232/485, Part No. 276970020)
Note: An adapter can be supplied for the power supply (5V/250mA) from the PC USB port to the converter. Please
make sure that the USB port is suitable for
high power devices. A connected ParameterBox is also supplied via this 5V.
2.5.2 Cable-Adapter assignment
The following table shows the necessary adapters for use with the various parameter boxes. The assignment of the
adapters to individual inverter series and the parameter boxes to be used can be obtained from the other table in
this section.
2.5.2.1 Adapter list
Serial No. Illustration Name Article number
1
“Modular cable
Straight RJ12 (6/6) - RJ12 (6/6) cable”
Not a NORD item
generally available
2
“Connection cable
M12 socket Æ RJ12”
Part No.: 278910230
3
“Connection cable
M12 plug Æ RJ12”
SK TIE4-M12-RJ12
Part No.: 275274600
4
“Connection cable
M12 socket Æ free leads”
Part No.: 278910200
5
“Connection cable
SUB-D 9 Æ free leads”
Part No.: 278910020
6
“Connection cable
M12 socket Æ SUB-D 9”
Part No.: 278910210
7
“Connection cable
USB2.0 plug A
to plug B”
Not a NORD item
generally available
8
Interface converter
“SK IC1-232/485”
Part No.: 276970020
9
„Connection cable
USB/5V Æ SK IC1-232/485“
Part No.: 278910220
RS 485 +
RS 485 -
GND
+ 5V
n.c.
n.c.
RS 485 +
RS 485 -
GND
+ 5V
n.c.
n.c.
RS 485 +
RS 485 -
GND
+ 5V
RS 485 +
RS 485 -
GND
+ 5V/+15V
To Next Page
Loading...