nord NORDAC PRO SK 511E Series - Explanation of Labels Used; List of Safety and Installation Notes

1 General
BU 0505 EN-3021 19
1.5.1 Explanation of labels used
DANGER
Indicates an immediate danger, which may result in death or serious injury.
WARNING
Indicates a possibly dangerous situation, which may result in death or
serious injury.
CAUTION
Indicates a possibly dangerous situation, which may result in slight or
minor injuries.
NOTICE
Indicates a possibly harmful situation, which may cause damage to the
product or the environment.
Note
Indicates hints for use and useful information.
Pos: 28 /Anleitungen/ Elektronik/FU und St arter/1. Allgemeines/ Sicherheits- und I nstallationshinwei se/Auflistung der Sicherheits- und Insta llationshinweise @ 1\m od_1341560303401_38 8.docx @ 30325 @ 3 @ 1
1.5.2 List of safety and installation notes
Pos: 29.1 /Anleitunge n/Elektronik/FU u nd Starter/1. Allge meines/Sicherheits- und I nstallationshin weise/Sicherhei tshinweise/... aus Kapitel "Sicherhei tshinweise"Gefahr - Elektrischer Schlag 1 @ 5\mod_1 399455445972_388.doc x @ 131078 @ @ 1
DANGER!
Electric shock
The device operates with a dangerous voltage. Touching certain conducting components (connection terminals,
contact rails and supply cables as well as the PCBs) will cause electric shock with possibly fatal consequences.
Even when the motor is at a standstill (e.g. caused by an electronic block, blocked drive or output terminal short-
circuit), the line connection terminals, motor terminals and braking resistor terminals (if present), contact rails,
PCBs and supply cables may still conduct hazardous voltages. A motor standstill is not identical to electrical
isolation from the mains.
Only carry out installations and work if the device is disconnected from the voltage and wait at least
5 minutes after the mains have been switched off! (The equipment may continue to carry hazardous voltages for
up to 5 minutes after being switched off at the mains).
Follow the 5 Safety Rules (1. Switch off the power, 2. Secure against switching on, 3. Check for no voltage,
4. Earthing and short circuiting, 5. Cover or fence off neighbouring live components).
Pos: 29.2 /Anleitunge n/Elektronik/FU u nd Starter/1. Allge meines/Sicherheits- und I nstallationshin weise/Sicherhei tshinweise/... aus Kapitel "Sicherhei tshinweise"Gefahr - Elektrischer Schlag 2 @ 5\mod_1 399455595133_388.doc x @ 131102 @ @ 1
DANGER!
Electric shock
Even if the drive unit has been disconnected from the mains, a connected motor may rotate and possible
generate a dangerous voltage. Touching electrically conducting components may then cause an electric shock
with possible fatal consequences.
Therefore prevent connected motors from rotating.
Pos: 29.3 /Anleitunge n/Elektronik/FU u nd Starter/1. Allge meines/Sicherheits- und I nstallationshin weise/Sicherhei tshinweise/... aus Kapitel "Sicherhei tshinweise"Warnung - E lektrischer Schlag 1 @ 5\mod_13 99455704227_388.d ocx @ 131125 @ @ 1
WARNING
Electric shock
The voltage supply of the device may directly or indirectly put it into operation, or touching electrically conducting
components may then cause an electric shock with possible fatal consequences.
Therefore, all poles of the voltage supply must be disconnected. For devices with a 3-phase supply,
L1 / L2 / L3 must be disconnected. For devices with a single phase supply, L1 / N must be disconnected. For
devices with a DC supply, –DC / +B must be disconnected. Also, the motor cables U / V / W
must be
disconnected.
Pos: 29.4 /Anleitunge n/Elektronik/FU u nd Starter/1. Allge meines/Sicherheits- und I nstallationshin weise/Sicherhei tshinweise/... aus Kapitel "Sicherhei tshinweise"Warnung - Elektrischer Sc hlag 2 (Erdung) @ 5\mod_13994557515 48_388.docx @ 131148 @ @ 1
Das verknüpfte Bild kann nicht angezeigt werden. Möglicherweise wurde die Datei
Das verknüpfte Bild kann nicht angezeigt werden. Möglicherweise wurde die Datei