nord NORDAC PRO SK 511E Series - Simplebox, SK CSX-0; Fig. 10 Simplebox SK CSX-0

SK 54xE – Users Manual for Frequency Inverters
80 BU 0505 EN-3021
Installation
Information
Installing the SK TU4-PNT-... technology unit
Modules should not be inserted or removed unless the device is free of voltage. The slots may only be used for
the intended modules.
Installation of a technology unit separate from the frequency inverter is not possible. It must be connected directly
to the frequency inverter.
The technology units must be installed as follows:
1. Switch off the mains voltage, observe the waiting
period.
2. Push the control terminals cover down slightly or
remove.
3. Remove the blank cover
by loosening the
release on the lower edge and pulling off with an
upward turning movement.
4. Hook the technology unit onto the upper edge
and press in lightly until it engages.
Take care that the plug connection bar is properly contacted and if necessary fix it with a suitable
screw (self-
tapping screw 2.9 mm x 9.5 mm, included in the scope of delivery of the frequency
inverter).
5. Close the control terminal cover again.
Pos: 110 /Anleitungen/ Elektronik/F U und Starter/3. Anzeige, Bedi enung und Optionen/SK 5 xxE/3.3 SimpleBox, SK CSX- 0 @ 0\mod_1327493009711 _388.docx @ 6329 @ 255555 @ 1
3.3 SimpleBox, SK CSX-0
This option is used as a simple parameterisation, display and
control tool for the frequency inverter SK 5xxE. even in active
BUS operation, data can be read out and parameterisation made
especially if the frequency inverter slot is occupied with a BUS
unit.
Features
• 4-digit, 7-segment LED display
• Single button operation of the frequency inverter
• Display of the active parameter set and operating value
After the SimpleBox has been attached, the cable connectors
plugged in and the mains has been switched on, horizontal lines
appear in the 4-digit 7-segment display. This display signals the
operational readiness of the frequency inverter.
If a jog frequency value is pre-
set in parameter P113, or a
minimum frequency is pre-set in P104, the display flashes with
this value.
If the frequency inverter is enabled, the display changes
automatically to the operating value selected in parameter
>Selection Display v
alue< P001 (factory setting = current
frequency).
The actual parameter set is shown by the 2 LEDs next to the
display on the left in binary code.
Fig. 10 SimpleBox SK CSX-0