nord NORDAC SK 5xxE Series - Page 124

NORDAC SK 5xxE Manual
124 Subject to technical alterations BU 0500 GB
Setting after commissioning
Parameter
No.
Name
Factory
setting
Super-
visor
P 1 P 2 P 3 P 4
P480 Function Bus I/O In Bits 0 S
P481 Function Bus I/O Out Bits 0 S
P482 Norm. Bus I/O Out Bits [%] 100 S
P483 Hyst. Bus I/O Out Bits [%] 10 S
ADDITIONAL PARAMETERS (5.6)
P502 Leading function value 0 S
P503 Leading function output 0 S
P504 Pulse frequency [kHz] 6.0 S
P505 (P) Abs. minimum frequency [Hz] 2.0 S
P506 Auto. fault acknowledgement. 0 S
P507 PPO Type 1
P508 Profibus address 0
P509 Source control word 0
P510 Setpoint source 0 (auto) S
P511 USS baud rate 3 S
P512 USS address 0
P513 Telegram time-out [s] 0.0 S
P514 CAN baud rate 4
P515 CAN address 50
P516 (P) Skip frequency 1 [Hz] 0.0 S
P517 (P) Skip frequency area 1 [Hz] 2.0 S
P518 (P) Skip frequency 2 [Hz] 0.0 S
P519 (P) Skip frequency area 2 [Hz] 2.0 S
P520 (P) Flying start 0 S
P521 (P) Flying start resolution [Hz] 0.05 S
P522 (P) Flying start offset [Hz] 0.0 S
P523 Factory setting 0
P533 Factor I
2
t-Motor [%] 100 S
P534 Torque-based disconn. Limit [%] 401 (off) S
P535 I
2
t motor 0 S
P536 Current limit 1.5 S
P537 Pulse switch-off [%] 150 S
P538 Mains voltage monitoring 3 S
P539 (P) Output monitoring 0 S
P540 Rotation direction mode 0 S
P541 Set output [hex] 0000 S
P542 Set analog output [V] 0.0 S
P543 (P) Bus - actual value 1 1 S
P544 (P)
Bus - actual value 2 0 S
P545 (P) Bus - actual value 3 0 S
P546 (P) Function Bus - set point 1 1 S