5.9 Parameter monitoring, User settings
BU 0500 GB Subject to technical alterations 125
Setting after commissioning
Parameter
No.
Name
Factory
setting
Super-
visor
P 1 P 2 P 3 P 4
P547 (P) Function Bus - set point 2 0 S
P548 (P) Function Bus - set point 3 0 S
P549 PotentiometerBox function 0 S
P550 ParameterBox Orders 0
P551 Drive profile 0 S
P552 CAN cycle time 0 S
P554 Min. chopper trigger point [%] 65 S
P555 P chopper limit [%] 100 S
P556 Braking resistance [Ω]
120 S
P557 Braking resistance power [kW] 0 S
P558 (P) Magnetisation time [ms] 1 S
P559 (P) DC lag period [s] 0.50 S
P560 Storage in EEPROM 1 S
POSITIONING (5.7) NOTE: Further details are listed and described in
manual BU 0510. (www.nord.com)
P600 (P) Position control 0 (off) S
P601 Actual position [rev] ---
P602 Actual Ref. Pos. [rev] ---
P603 Curr. position. diff. [rev] --- S
P604 Encoder type 0 S
P605 Absolute encoder 10 S
P607 Ratio 1 S
P608 Reduction ratio 1 S
P609 Offset position [rev] 0 S
P610 Sollwert-Modus 0 S
P611 Lageregeler P [%] 5 S
P612 Pos. Window [rev] 0 S
P613 Position [rev] 0 S
P615 Maximum position [rev] 0 S
P616 Minimum position [rev] 0 S
P625 Hysteresis output [rev] 1 S
P626 Relais position [rev] 0 S
P630 Position slip error [rev] 0 S
P631 Abs/Inc slip error [rev] 0 S
P640 Unit of pos. value 0 S
To Next Page
Loading...
