2 Assembly and installation
BU 0500 GB Subject to technical alterations 17
2.3 Mounting dimensions
2.3.1 SK 5xxE, standard version
2 brackets are supplied for the wall mounting of the SK 5xxE. These are inserted into the cooling element at
the rear of the device as shown in the illustration. For this, no further accessories are needed.
Alternatively, the wall mounting brackets can be inserted at the side of the cooling element in order to minimise
the necessary depth of the control cabinet.
In general, care must be taken that the rear of the cooling element is covered with a flat surface and that the
device is mounted vertically. This enables optimum convection, which ensures fault-free operation.
B
A
D
Section
2.2.1
To Next Page
Loading...
