nord NORDAC SK 5xxE Series - Page 44

NORDAC SK 5xxE Manual
44 Subject to technical alterations BU 0500 GB
Functions of the SimpleBox:
7 Segment
LED display
When the frequency inverter is ready for operation any initial value (P104/P113 for keyboard
operation) is indicated by a flashing display. This frequency is immediately used on being enabled.
During operation, the currently set operating value (selection in P001) or an error code (Section 6) is
displayed.
During parameterisation, the parameter numbers or the parameter values are shown.
The LEDs indicate the actual operating parameter set in the operating display (P000) and the current
parameter set being parameterised. The display is in binary code.
LEDs
1
2
1
2
= P1
2
1
= P2
1
2
= P3
2
1
= P4
Turn the knob
to the right
Turn the knob to the right in order to increase the parameter number or the parameter value.
Turn the knob
to the left
Turn the knob to the left in order to reduce the parameter number or the parameter value.
Briefly press
the knob
Briefly pressing the knob = “ENTER” function in order to store a changed parameter or to change from
parameter number to parameter value.
Press the knob
for longer
If the knob is pressed for a longer period, the display changes to the next higher level, if necessary
without storing a parameter change.
Menu structure with the SimpleBox
P0--
_ _ _ _
P1--
P2--
P4--
P5--
P6--
P7--
P001
P002
P100
P101
P114
P200
P201
P220
P400
P401
P483
Opera ting value s
display (or operational)
following mains ON
P3--
P300
P301
P327
P003
NOTE: Parameters P465, P475, P480…P483, P502, P510, P534, P701…P706, P707, P718, P740/741
and P748 have additional levels (arrays), in which further adjustments can be made, e.g.:
P_01
P502
P_02
off
off
Setting:
Value of leading function1
Setting:
Value of leading function2
ENTER
ENTER
ENTER
VALUE