nord sk 200e - General Introduction; General Safety and Operating Precautions; Possible Required Tools

www.nord.com
2
General
Introduction
Bayer SK200E Troubleshooting Guide – Subject to Change Without Notice
General Safety and Operating Precautions
• During operation, drive power converters may, depending on their protection class, have live, bare,
 moving,orrotatingpartsorhotsurfaces.
• Unauthorizedremovalofcovers,improperuse,incorrectinstallationoroperationcausesariskofserious
 personalinjury,severematerialorpropertydamage,orlossoflife.
• All transportation, installation, initialization, and maintenance work must be carried out by qualied
 personnel. For thepurposesofthesebasicsafetyinstructions,qualiedpersonnel arepersons whoare
 familiarwiththeassembly,installation,commissioning,andoperationofthisproductandwhohaverel-
 evantqualicationsfortheirwork.
• InstallationandothermaintenanceworkmayonlybecarriedoutwiththeACVectorDrivedisconnected
 frommainssupplyvoltage.
• Localandnationalelectricalcodesandregulationsmustbecompliedwithfortheinstallationofelectrical
 equipmentandaccidentprevention.
• Theequipmentcontinuestocarryhazardous voltagesforupto5minutesafterbeing disconnectedfrom
 mainssupplyvoltage.
• Evenduringmotorstandstill,thelineconnectionterminals,motorterminals,andbrakingresistorterminals
maystillconducthazardousvoltages.Amotorstandstillisnotidenticaltoelectricalisolationfromthemains.
• Controlcables,linecables,andmotorcablesmustbelaidseparately.Innocircumstancesshouldtheybe
 laidinthesameprotectiveconduit/cabletrays.
• TheACVectorDrivemustbeproperlygrounded.
• DonotuseACVectorDrivein“Open-Delta”or“Corner-Grounded”systems.
GENERAL WARNINGS
Introduction
Thisstartup&troubleshootingguideisintendedtobeusedwiththe
SK200EACvectordrivesusedonBayerOnDemand™seedtreatment
systems.Thisdocumentwillcoverpotentialstartupandcommission-
ingissuesandrelatedsolutionsfortheSK200Eproduct.Thegearmo-
torandvectordrivecombinationwillbediscussed,aswellasgeneral
topicsvalidforthisconguration.
Possible Required Tools
 4mm Hex Wrench
 SmallFlatBladeScrewdriver
 LargeFlatBladeScrewdriver
 AC/DCMultimeter
 LaptopwithNORDCONsoftwareandserialcable*
(Nordp/n78910240)
OR
 Handheldoperator/keypad:SKPAR-3H
(Nordp/n75281014)
* Note -Iflaptopdoesnothaveaserialport,aUSB-RS232convertermayberequired.
(NotavailablethroughNORD)
Figure 1 - Possible required tools




*


