17
6. SYMPTOM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY
a. Remove the screws from the hood. Carefully remove the hood.
Locate the Reed Switch (74) and the Magnet (95) on the left side
of the Pulley (17). Turn the Pulley until the Magnet is aligned with
the Reed Switch. Make sure that there is a 1/8Ógap between
the Magnet and the Reed Switch. If necessary, loosen the
Screw (90) and move the Reed Switch slightly. Retighten the
Screw. Re-attach the hood, and run the treadmill for a few min-
utes to check for a correct speed reading.
95
74
90
Top
View
1/8Ó
17
To Next Page
Loading...
