15, See drawing 15a. Slide the Rear Shroud (15)
under the Top Cover (24),
Attach the Top Cover (24) and the Front and Rear
Shrouds (14, 15) to the Top Frame (12) with three
M4 x 16mm Selfotapping Screws (99),
See drawing 15b. Attach the Rear Shroud (15) to
the Base (1) with an M4 x 16mm Selfotapping
Screw (99),
16, Attach the Backrest (18) to the Upright (3) with
two M6 x 100mm Screws (113) and two M6
Washers (107),
17, Attach the Seat (19) to the Seat Frame (4) with
two M6 x 16mm Screws (87) and an M6 x 85mm
Screw (85),
Set the Seat Frame (4) onto a set of posts on the
Upright (3),
18, Attach the Bumper (115) to the Leg Developer (6)
with an M4 x 19mm Selfotapping Screw (100),
Grease an M10 x 75mm Bolt (86), Attach the Leg
Developer (6) to the Seat Frame (4) with the Bolt
and an M10 Nylon Locknut (108), Do not over-
tighten the Locknut; the Leg Developer must
be able to pivot easily.
15a
15b
16
17
18
-'I 24
10
To Next Page
Loading...
