Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by almost anyone. However, the weight
system has many parts and the assembly
process wiii take time, By setting aside plenty of
time. assembly will go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
Because of its weight and size, the weight sys-
tem should be assembled in the location where it
will be used. Make sure that there is enough
clearance to walk around the weight system as
you assemble it.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
, Tighten all parts as you assemble them, unless
instructed to do otherwise,
As you assemble the weight system, make sure
all parts are oriented as shown in the drawings,
, For hetp identif iyjng small parts, use the PART
IDENTIFICATION CHART.
The included allen wrench _ and
grease, and the following toots (not included)
may be required for assembly:
• Two adjustable wrenches
• One rubber maltet
• One standard screwdriver
• One Philtips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
understand the information in the box
above. For help identifying small parts, use
the PART iDENTmFICATION CHART in the
center of this manual
Attach a Wheel (32) to a Wheel Cap (31) with an
M8 x 65mm Button Bolt (94) and an M8 Nylon
Locknut (110). Do not overtighten the Locknut;
the Wheel must be able to pivot easily.
Attach the Wheel Cap (31) to the Base (1) with
two M4 x 16mm Self-tapping Screws (99).
Repeat this step with the other Wheel Cap (31}.
Attach a Locking Caster (76) to the Base (1) with
four M8 x 20mm Button Bolts (92) and four M8
Nylon Lecknut (110).
Repeat this step with the other Locking Caster
(76).
99
94
32
31
92
92
110 110
31
To Next Page
Loading...
