Attach the Weight Guide (13) to the Base (1) with
an MIO x 50mm BoUt(96), two MIO Washers
(105), an 16mm x 6mm Spacer (11), and an MIO
NyUonLocknut (108).
Attach the Weight Guide With HoJe (36) to the
Base (1} in the same manner. Make sure that
the indicated hoJe in the Weight Guide is clos-
er to the bottom.
Locate the fourteen Weights (27) that do not have
Weight Bushings (30) pressed into them. Press
two Weight Bushings into the outside hoUesof
each Weight. Make sure that ai! of the Weights
are oriented as shown with the pin hoJes on
the bottom.
SHde two Weight Bumpers (29) onto the Weight
Guides (13, 36). SHde the fourteen Weights (27)
onto the Weight Guides.
Unsertthe Weight Tube (16) into the center hoUein
the fifteenth Weight (27). Tap the RoH Pin (79)
into the top hoUein the Weight Tube. Make sure
that the Pin is underneath the Weight and is
centered in the Weight Tube.
Slide the Weight (27) onto the Weight Guides (13,
36).
See drawing 6b. Attach the Front Shroud (14) to
the Base (1) with an M4 x 16mm Self-tapping
Screw (99).
See drawing 6a. Note: if the Press Arm Cable
(not shown} has been routed through the Top
Cover (24), make sure that the CabJe crosses
under the Top Frame (!2) and hangs between
the Weight Guides (13, 36} while this step is
completed.
Attach the Top Frame (12) to the Weight Guides
(13, 36) with two MIO x 65mm Bolts (95), four
MIO Washers (105), two 16mm x 6mm Spacers
(11), and two MIO Nylon Locknuts (108). Do not
tighten the Locknut.
Attach the Top Frame (12) to the Upright (3) with
two MIO x lOOmm Button Bolts (91) and an MIO
Nylon Locknut (108).
Set the Top Cover (24) over the Front Shroud
(14) and the Top Frame (12).
Tighten the MIO Nyton Locknuts (!08} used in
steps 3 and 6.
6a
6b
95
12
14
99
79
Hole
1O8
105
105
105
108
7
To Next Page
Loading...
