Refer to the CABLE DIAGRAM on page !7 to
ensure correct cable routing during steps 7
through 14.
Use the wire in the Left Press Arm (7) to pun the
Press Arm CaMe (66) up through the Press Arm,
Make cure that the Cable is routed around the
pulteys above the Precc Arm as chown in the
inset drawing.
Hold a 4" PuNey (42) over the Press Arm Cable
(66), Attach the PuNey inside of the Swivel Arm
(26) with an MIO x 50mm Button BoUt(88), two
MIO Washers (105), two 16mm x 6mm Spacers
(11), and an MIO Nylon Locknut (108),
Route the Press Arm CaMe (66) over a 3 1/2"
PuNey (43), Attach the PuNey and a CaMe Trap
(47) to the Top Frame (12) with an MIO x 40mm
Screw (97), Make cure that the Cable Trap is
oriented to hold the Cabte in the groove of the
Pultey.
Route the Press Arm Cable (66) through the Top
Cover (24) and over a 3 1/2" Pulley (43), Attach
the Pulley and a Cable Trap (47) to the Top
Frame (12) with an MIO x 40mm Screw (97),
Make cure that the Cable Trap is oriented to
hotd the Cabte in the groove of the Pulley.
10, Route the Press Arm Cable (66) under a 3 1/2"
Pulley (43), Attach the Pulley, a Cable Trap (47),
and two Finger Guards (48) to the second hole
from the top of the Weight Tube (16) with an MIO
x 50mm Bolt (96) and an MIO Nylon Locknut
(108), Make cure that the Cable Trap is orient-
ed to hotd the Cable in the groove of the
Pulley.
12
24
12
\
66
47
97
66
6 48
108
47
t8 43
8
To Next Page
Loading...
