11, Route the Press Arm CabHe (66) over a 3 1/2"
PuHHey(43), Attach the PuHHeyand a CaMe Trap
(47) to the Top Frame (12) with an MIO x 40mm
Screw (97), Make sure that the Cable Trap is
oriented to hold the Cable in the groove of the
Pultey.
12, Route the Press Arm CaMe (66) through the Top
Cover (24) and over a 3 1/2" PuHHey(43), Attach
the PuHHeyand a CaMe Trap (47) to the Top
Frame (12) with an MIO x 40mm Screw (97),
Make sure that the Cable Trap is oriented to
hotd the Cabte in the groove of the Pultey.
13, Use the wire in the Right Press Arm (8) to puHHthe
Press Arm CaMe (66) down through the Press
Arm, Make sure that the Cable is routed
around the pulleys above the Press Arm as
shown in the inset drawing.
HoHda 4" PuHHey(42) over the Press Arm CaMe
(66), Attach the PuHHeyinside of the SwiveH Arm
(26) with an MIO x 50mm Button BoHt(88), two
MIO Washers (105), two 16mm x 6mm Spacers
(11), and an MIO NyHonLocknut (108),
14, Orient the CaMe Cover (63) as shown and sHideit
onto the Press Arm CaMe (66),
Hnsertthe Press Arm CaMe (66) into the CaMe
CoupHer (64), Tighten four M6 x lOmm Set
Screws (114) into the CoupHer to hoHdthe CaMe in
place,
Slide the Cable Cover (63) over the Cable
Coupler (64),
11
12
13
14
47
43
12
J
J
f
88
114
64
63
114
9
To Next Page
Loading...
