NordicTrack 360 W/freemotion - Page 11

11
20. Attach an Arm Pad (21) and an Arm Pad Base
(22) to the Dip Arm (5) with two M6 x 70mm
Screws (93).
Repeat this step on the other side of the Dip
Arm (5).
22. Attach the Curl Pad (20) to the Curl Post (9) with
two M6 x 16mm Screws (87).
23.
Make sure that all parts are properly tightened
before using the weight system. The use of the
remaining parts will be explained in the ADJUST-
MENTS section, beginning on the following page.
21. Insert a Pad Tube (17) into the Leg Developer
(6). Slide two Leg Pads (23) onto the Pad Tube.
Slide two Leg Pads (23) onto the Seat Frame (4).
3
3
1
0
3
4
3
5
5
1
102
102
20
21
21
22
93
5
5
6
4
17
23
23
23
23
20
9
87
22
19. Attach a Front and Rear Dip Cap (33, 34) around
a Dip Handle (10) with two M3 x 32mm Self-tap-
p
ing Screws (102).
T
ighten a Dip Arm Knob (51) into the Dip Arm (5).
Pull the Knob out as far as it will go and insert the
Dip Handle (10) through a Dip Arm Bushing (35)
and into the Dip Arm. Engage the Knob into the
Dip Handle.
Repeat this step on the other side of the Dip
Arm (5).
1
9