11
13. Use the wire in the Right Press Arm (8) to pull
the Press Arm Cable (66) down through the
Press Arm. Make sure that the Cable is rout-
ed around the pulleys above the Press Arm
as shown in the inset drawing.
Hold a 4" Pulley (42) over the Press Arm Cable
(66). Attach the Pulley inside of the Swivel Arm
(26) with an M10 x 50mm Button Bolt (88), two
M10 Washers (105), two 16mm x 6mm Spacers
(11), and an M10 Locknut (108).
12. Route the Press Arm Cable (66) through the
Top Cover (24) and over a 3 1/2" Pulley (43).
Attach the Pulley and a Cable Trap (47) to the
Top Frame (12) with an M10 x 40mm Screw
(97). Make sure that the Cable Trap is orient-
ed to hold the Cable in the groove of the
Pulley.
12
12
43
24
47
97
66
88
105
13
105
108
66
8
66
42
11
11
26
11. Route the Press Arm Cable (66) over a 3 1/2"
Pulley (43). Attach the Pulley and a Cable Trap
(47) to the Top Frame (12) with an M10 x 40mm
S
crew (97). Make sure that the Cable Trap is
oriented to hold the Cable in the groove of
t
he Pulley.
12
66
43
11
47
97
To Next Page
Loading...
