14
22. Attach the Curl Pad (20) to the Curl Post (9)
with two M6 x 16mm Screws (87).
23. Make sure that all parts are properly tightened before you use the weight system. The use of the remaining
parts will be explained in the ADJUSTMENT section, beginning on page 15.
21. Insert a Pad Tube (17) into the Leg Developer
(6). Slide two Leg Pads (23) onto the Pad Tube.
Slide two Leg Pads (23) onto the Seat Frame
(4).
21
6
4
17
23
23
23
23
20
9
87
22
20. Attach an Arm Pad (21) and an Arm Pad Base
(22) to the Dip Arm (5) with two M6 x 70mm
Screws (93).
Repeat this step on the other side of the Dip
A
rm (5).
20
2
1
2
2
93
5
To Next Page
Loading...
