NordicTrack 360 - CHANGING WEIGHT SETTING; LOCKING THE WEIGHT STACK; ADJUSTING THE CABLE

19
28
27
CHANGING THE WEIGHT SETTING
To change the setting of the weight stack, insert the
W
eight Pin (28) under the desired Weight (27).
Insert the Weight Pin so that the bent end touches
t
he weight stack. Turn the bent end down.
Note: Due to the cables and pulleys, the amount
of resistance at each exercise station may vary
from the weight setting. Use the WEIGHT
RESISTANCE CHART on page 20 to find the
approximate amount of resistance.
78
77
36
48
66
48
43
47
16
96
108
LOCKING THE WEIGHT STACK
To lock the weight stack, insert the Lock Pin (78)
into the indicated hole in a Weight Guide With Hole
(36). Insert the Lock (77) through the hole in the
Weight Pin and close the Lock.
ADJUSTING THE CABLE
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cable before resistance is felt,
the cables should be tightened.
To tighten the cable, remove the M10 x 50mm Bolt
(96) from the Weight Tube (16). Reattach the 3 1/2"
Pulley (43), the Cable Trap (47), and the two Finger
Guards (48) to a lower hole in the Weight Tube with
the Bolt and an M10 Locknut (108). Make sure that
the Cable Trap is oriented to hold the Press Arm
Cable (66) in the groove of the Pulley. To loosen
the Cable, attach the Pulley to a higher hole in the
Weight Tube.